Overhead Cantilever Filter Press
Cantilever filter press" Cantilever design is adopted, the cantilever in plate pulling system is provided with good corrosion-proof filter cloth, by which, the feeding, discharging and cleaning operations are more convenient, discharging operation is more smooth, the structural force is...
Cantilever filter press"
Cantilever design is adopted, the cantilever in plate pulling system is provided with good corrosion-proof filter cloth, by which, the feeding, discharging and cleaning operations are more convenient, discharging operation is more smooth, the structural force is balanced, and the performance is reliable."
Proper wire rope shall be selected and the center of gravity shall be aligned for hoisting. Liner of soft materials shall be used in contact region of the steel rope and components, any components shall not be damaged. Please refer to Figure 2.
(1) The equipment shall be installed on the building about 2-5m above the ground for the unloading and transportation of filter cake, and it shall not be installed at open places, or it can be installed on the ground as required by the customer.
(2) The foundation shall be laid properly before installation; preformed hole for anchor bolt shall be set for secondary grouting. See the technical parameter table for similar type for the installation size of foundation.
(3) The leg of feed inlet end shall be fixed with bolts after calibration and leveling of equipment (the filter press below 60m2 does not need to be fixed).
(4) The installation place is not suitable to be too far from the material processing places.
(5) The electrical control cabinet shall be far away from the place that can be contacted by corrosive source or water to avoid the electrical apparatus element from being damaged and influencing the normal work.
(6) The customer can install the pipe system according to pipe layout (refer to Figure 8) and the actual on-site conditions, in which, the convenience of installation, application and maintenance shall be ensured. The pipeline shall be short and less turning to the largest extent, the water from closed-channel flow shall not be discharged in an upward direction, if any, a self-priming pump shall be installed.
(7) Power line and other cables shall be connected with the electrical control cabinet according to the terminal wiring diagram of electrical control cabinet, and check that the connection is correct.