Categories

Contact Us

Jiangsu Xingxin Separation Equipment Manufacturing Co.,Ltd

Address: No.3 Huanxi Road, East Industrial Park, Taixing City, Jiangsu Province, China

Tel: +86-523-87688503

M/P: +86-523-87690789

E-mail: info@xxylj.com

Pulling Plate for Filter Press

Pulling Plate for Filter Press

Pulling plate" Plate puller consists of two pulling plate device, link chain (stainless steel chains are available) and a set of chain wheels" Hydraulic system is power source of compressing mechanism and plate pulling mechanism. Commissioning of automatic plate pulling: (1) Adjust the...

Product Details

Pulling plate"
Plate puller consists of two pulling plate device, link chain (stainless steel chains are available) and a set of chain wheels"
Hydraulic system is power source of compressing mechanism and plate pulling mechanism.

 

Commissioning of automatic plate pulling:
(1) Adjust the bolt on the tensioned sliding plate to ensure the tension of link chain is proper.
(2) Press button for adjustment of plate puller, check whether the pulling plate is flexible, reliable and synchronized, whether the pulling speed is normal; the plate pulling pressure shall be adjusted at 3.0-4.0 MPa.

 

Plate pulling and discharging mechanism
The plate pulling and discharging of this series of filter press can be realized by both manual and automatic modes.
(1) Manual plate pulling mode: Two workers at both sides pull open the plate for discharging.
(2) Full-automatic plate pulling mode:
The hydraulic motor will drive the two manipulators to move forward in process of discharging. Such manipulators move to the first filter plate and stop moving when contacting the handle; the proximity switch sends out signals to make solenoid directional valve to change direction; the manipulators then grasp the first filter plate and move backward until the grasped filter plate contacts the push plate, the proximity switch sends out signals to make solenoid directional valve to change direction again, making the manipulators move forward, such actions will be repeated until all plates are pulled. After the completion of plate pulling, the manipulators will reset after a blank cycle.
Full-automatic plate pulling and discharging mechanism consists of plate pulling manipulator, drive system, tightening mechanism, etc.
a) Manipulator
The manipulator includes conveyor claw and lock claw, which are all installed with torsional springs.
b) Drive mechanism
The power for pulling plate comes from hydraulic pump and hydraulic motor, which drive the synchronous motion of two manipulators via chain wheel and link chain.
c) Tightening mechanism
The tightening mechanism is installed outside the girder at thrust plate. The link chain shall be tightened properly as the link chain may be lengthened after a period of use. The fixed bolts of sliding plate can be loosened to adjust the screw. The fixed bolt must be tightened after the adjustment. It cannot be over tightened, or the service life of link chain will be affected.


Hot Tags: pulling plate for filter press, China, manufacturers, suppliers, factory, customized, for sale
Related Products

Inquiry